Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Mitsubishi Lancer EvolutionFACTORY OEM SERVICE PROCEDURE
Technical Bulletins: Campaigns
- Air Bag, SRS
- CALIFORNIA Department Of Motor Vehicles (DMV) - TAKATA Recalls (TIN-24-00-005)
- ALABAMA Law Enforcement Agency Commission Letterhead - TAKATA Recalls (TIN-24-00-003)
- TEXAS Department Of Motor Vehicles Letterhead - TAKATA Recalls (TIN-24-00-002)
- Lancer Passenger Side Frontal Air Bag Inflator - Safety Recall Campaign - Revised (SR-17-004 REV)
- Lancer Passenger Side Frontal Air Bag Inflator - Safety Recall Campaign - Revised (SR-18-005 REV)
- New YORK State Department Of Motor Vehicles Letterhead - TAKATA Recalls (TIN-22-00-015)
- South CAROLINA Department Of Public Safety Letterhead - TAKATA Recalls (TIN-22-00-014)
- PENNSYLVANIA Department Of Transportation Letterhead - TAKATA Recalls (TIN-22-00-003)
- Lancer Passenger Side Frontal Air Bag Inflator - Safety Recall Campaign - Revised (SR-14-012REVII)
- Lancer Passenger Air Bag Inflator - Special Service Campaign (SC-14-004)
- Air Bag Warning Label Service Campaign (SC-04-006)
- Auxiliary Emission Control Systems
- Engine Control Systems
- Exhaust
- Exterior Body Panels
- Frames, Subframes & Crossmembers
- Front Suspension
- Identification
- Mechanical
- System
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.