Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Mitsubishi Lancer EvolutionFACTORY OEM SERVICE PROCEDURE
Torque Specifications
A/C TORQUE SPECIFICATIONS
| Application | Ft. Lbs (N.m) | |
|---|---|---|
| Compressor Pulley Nut | 11-13 (15-17) | |
| INCH Lbs. (N.m)Β | ||
| Refrigerant Lines | ||
| Discharge Hose-To-Condenser Nut | 90-124 (10-14) | |
| Liquid Line-To-Condenser Nut | 35-51 (4.0-5.8) | |
| Liquid Line Fitting | 106-124 (12-14) | |
| Compressor Hose Bolts | 90-124 (10-14) | |
| Evaporator Line Bolt | 90-124 (10-14) | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
