2004 Mitsubishi Lancer EvolutionFACTORY OEM SERVICE PROCEDURE

Test Procedure

  1. Start the engine with all the accessories switched OFF.
  2. Drive the vehicle for 3 minutes at the following conditions. (During the monitor)
    • Engine speed: More than 500 r/min, less than 3,000 r/min
    • Engine load: More than 25%
    • Without rapid accelerator pedal change
    • Except fuel cut
  3. Stop the vehicle at the safe place and turn the ignition switch to "LOCK" (OFF) position.

Start the engine and do Steps 1 to 3 again. Confirm that the diagnostic trouble code (DTC) is not output.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.