2004 Mitsubishi Lancer EvolutionFACTORY OEM SERVICE PROCEDURE

Component Testing: Rotor

WARNING: This page is about a different car, the 2004 Mitsubishi Eclipse. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check the continuity between the slip rings of the field coil. If the resistance value is not within 2-5ohm, replace the rotor. See Fig 1 .
  2. Check the continuity between the slip ring and the core. If there is continuity, replace the rotor. See Fig 2 .
Fig 1: Checking Continuity Between Slip Rings & Field Coil
G00352952Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.