Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Mitsubishi Lancer EvolutionFACTORY OEM SERVICE PROCEDURE
Section 55 (Multi-Center Display)
WARNING: This page is about a different car, the 2004 Mitsubishi Galant. However, it is still accessible from the selected car via links, so may be relevant.
- General Description
- Notes
- Character Display Function Of Low Grade Multi-Center Display
- Graphical Display Function Of Middle Grade Multi-Center Display
- Precautions During Service
- Multi-Center Display System < Middle Grade Type >
- Diagnosis Function
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC 010: Buss Off
- DTC 011: Powertrain Control Module Time-Out (Related To Engine) DTC 012: Powertrain Control Module Time-Out (Related To A/T)
- DTC 013: A/C-Ecu Time-Out
- DTC 014: Combination Meter Time-Out
- DTC 019: ETACS-Ecu Time-Out
- DTC 020: Failures Information On Powertrain Control Module (Related To Engine)
- DTC 021: Failures Information On Combination Meter
- DTC 022: Failures Information On A/C-Ecu
- Diagnosis
- Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: Communication With Scan Tool Is Not Possible (Middle Grade Type)
- Inspection Procedure 2: The Multi-Center Display Does Not Show Any Information. (Middle Grade Type)
- Inspection Procedure 3: The A/C Display Shows "Communication Error", And Then Can Not Proceed To Next Screen. (Middle Grade Type)
- Inspection Procedure 4: The Ambient Air Temperature Display Shows "Com Error" Or "-°C (-°F)." (Middle Grade Type)
- Inspection Procedure 5: On The Audio Screen, "Communication Error" Can Not Proceed To Next Screen. (Middle Grade Type)
- Inspection Procedure 7: The Compass Can Not Be Calibrated Manually, Or Becomes Out Of Calibration Easily (Middle Grade Type)
- On-Vehicle Service
- Special Tools
- Multi-Center Display
- Ambient Temperature Sensor
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
