Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Mitsubishi Lancer EvolutionFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator - Evolution: Switches
SWITCHES LOCATION
| Component | Location |
|---|---|
| A/C Refrigerant Temperature Switch | On A/C compressor. See Figure . |
| Brake Fluid Level Indicator Switch (B-05) | On brake master cylinder reservoir. See Figure . |
| Clutch Interlock Switch (C-131) | Left side of dash. See Figure . |
| Clutch Pedal Position Switch (C-130) | Above clutch pedal, on bracket. See Figure . |
| Door Lock Key Cylinder Switch (LH) (E-01) | In left front door. See Figure . |
| Door Switch (LH Rear) | At left rear door. See Figure . |
| Door Switch (RH Rear) | At right rear door. See Figure . |
| Dual Pressure Switch | On right side of engine compartment. See Figure . |
| Engine Oil Pressure Switch (B-23) | At rear of engine. See Figure . |
| Key Reminder Switch (C-207) | In steering column. See Figure . |
| Parking Brake Switch (D-28) | At base of parking brake lever. See Figure . |
| Power Steering Oil Pressure Switch | On power steering pump. See Figure . |
| Power Steering Pressure Switch (A-40) | Right front of engine compartment. See Figure . |
| Seat Belt Switch (D-20) | Inside driver's seat belt buckle. See Figure . |
| Stoplight Switch | Above brake pedal, on bracket. See Figure . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
