Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Mitsubishi Lancer EvolutionFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator - Evolution: Miscellaneous
MISCELLANEOUS LOCATION
| Component | Location |
|---|---|
| Audio Amplifier (D-41) | Under driver's seat. See Figure . |
| Battery | Left rear of engine compartment. See Figure . |
| Data Link Connector (2) | Below left side of dash. See Figure . |
| Engine Speed Detection Connector | In engine compartment relay box. See Figure . |
| Generator (B-24) | Front of engine. See Figure . |
| Grounding Cable | On top of intake manifold. See Figure . |
| Horn (Hi) | Behind left end of front bumper fascia. See Figure . |
| Horn (Lo) | Behind left center of front bumper fascia. See Figure . |
| Ignition Coil (1) (B-103) | At rear of engine. See Figure . |
| Ignition Coil (2) (B-114) | Top front of engine. See Figure . |
| Injector (1) (B-22) | At top front of valve cover. See Figure . |
| Injector (2) (B-20) | At top front of valve cover. See Figure . |
| Injector (3) (B-18) | At top center of valve cover. See Figure . |
| Injector (4) (B-17) | At rear of engine. See Figure . |
| Joint Connector No. 1 (C-05) | Behind center of dash. See Figure . |
| Joint Connector No. 2 (C-101) | Behind instrument cluster. See Figure . |
| Joint Connector No. 3 (C-06) | Behind right side of dash. See Figure . |
| Joint Connector No. 5 (C-21) | Behind instrument cluster. See Figure . |
| Joint Connector No. 6 (C-105) | Behind lower center of dash. See Figure . |
| Resistor (C-09) | Behind right side of dash, on HVAC unit. See Figure . |
| Seat Belt Pretensioner (Left) (D-16) | At base of left "B" pillar, behind trim. See Figure . |
| Seat Belt Pretensioner (Right) | At base of right "B" pillar, behind trim. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.