2004 Mitsubishi Lancer EvolutionFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator - Evolution: Connectors

CONNECTORS LOCATION

Component Location
A12 (Black, 2 Pin) At left rear of engine compartment, near underhood fuse/relay block. See Figure .
A13 (Black, 12 Pin) At left rear of engine compartment, near underhood fuse/relay block. See Figure .
A29 (Black, 8 Pin) At left rear of engine compartment, near underhood fuse/relay block. See Figure .
B14 (Black, 10 Pin) At left rear of engine compartment, near underhood fuse/relay block. See Figure .
B27 (Black, 6 Pin) At rear of engine. See Figure .
C10 (7 Pin) Behind right side of dash, above glove box. See Figure .
C17 (20 Pin) Behind left side of dash, above junction block. See Figure .
C18 (6 Pin) Behind left side of dash, above junction block. See Figure .
C109 (2 Pin) Behind right side of dash, above connector block. See Figure .
C110 (16 Pin) Behind right side of dash, above connector block. See Figure .
C111 (13 Pin) Behind right side of dash, in connector block. See Figure .
C112 (Gray, 9 Pin) Behind right side of dash, in connector block. See Figure .
C113 (25 Pin) Behind right side of dash, in connector block. See Figure .
C122 (Blue, 22 Pin) Below center of dash. See Figure .
C123 (Gray, 10 Pin) Below center of dash. See Figure .
C124 (25 Pin) Below center of dash. See Figure .
C126 (3 Pin) Behind left side of dash, in connector block. See Figure .
C127 (13 Pin) Behind left side of dash, in connector block. See Figure .
C129 (25 Pin) Behind left side of dash, in connector block. See Figure .
C133 (2 Pin) Behind left side of dash, near connector block. See Figure .
C134 (Black, 11 Pin) Behind left side of dash, in connector block. See Figure .
D04 (8 Pin) (D-04) At right "B" pillar. See Figure .
D15 (8 Pin) At left "B" pillar. See Figure .
D21 (4 Pin) Under center console. See Figure .
D33 (1 Pin) Under right rear seat. See Figure .
D34 (8 Pin) Under right rear seat. See Figure .
D35 (6 Pin) Under right rear seat. See Figure .
F12 (Gray, 2 Pin) Behind left side of rear bumper. See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.