Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Mitsubishi Lancer EvolutionFACTORY OEM SERVICE PROCEDURE
Door - Evolution
- Door
- Door Diagnosis
- Introduction To Glass And Door Diagnosis
- Glass And Door Diagnostic Troubleshooting Strategy
- Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: Water Leak Through Door Window Glass
- Inspection Procedure 2: Door Window Glass Malfunction
- Inspection Procedure 3: Water Leak Through Door Edge
- Inspection Procedure 4: Water Leak From Door Center
- Inspection Procedure 5: Door Hard To Open
- Inspection Procedure 6: Door Does Not Open Or Close Completely
- Inspection Procedure 7: Uneven Gap Between Body
- Inspection Procedure 8: Wind Noise Around Door
- How To Locate Wind Noise
- Special Tools
- On-Vehicle Service
- Door Fit Adjustment
- Door Window Glass Adjustment
- Glass Sliding Mechanism Check And Adjustment
- Power Window Timer Function Check
- Power Window Operating Current Check
- Power Window Relay Check
- Circuit Breaker (Incorporated In The Power Window Motor) Inspection
- Power Window Check
- Central Door Locking System Inspection
- Door Outside Handle Play Check
- Door Inside Handle Play Adjustment
- Door Assembly
- Door Glass And Regulator
- Door Handle And Latch
- Window Glass RUNCHANNEL And Door Opening Weatherstrip
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
