2004 Mitsubishi Lancer EvolutionFACTORY OEM SERVICE PROCEDURE

General Service Specifications: Specifications

COOLING SYSTEM SPECIFICATIONS

Application Specification
Coolant Replacement Interval (1)
Coolant Capacity (Includes Heater & Reserve Tank)
2.0L 6.3 Qts. (6.0L)
2.4L 7.4 Qts. (7.0L)
Pressure Cap 14-18 psi
Thermostat Opens
Except Lancer Evolution
Starts To Open 180°F (82°C)
Fully Open 203°F (95°C)
Lancer Evolution
Starts To Open 176°F (80°C)
Fully Open 199°F (93°C)
(1) Change coolant at first 4 years or 60,000 miles, then change after every 2 years or 30,000 miles.

THERMOSTAT R & I 

WATER PUMP R & I 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.