Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Mitsubishi Galant LSFACTORY OEM SERVICE PROCEDURE
Fastener Tightening Specifications
Fastener Tightening Specifications
| ITEM | SPECIFICATION |
|---|---|
| Auto-cruise control system | |
| Lower cover cap bolt | 9.0 ± 2.0 N.m (80 ± 17 in-lb) |
| Steering wheel assembly nut | 41 ± 8 N.m (30 ± 6 ft-lb) |
| Emission control system | |
| EGR valve bolt | 24 ± 3 N.m (18 ± 2 ft-lb) |
| Grounding bolt <2.4L Engine> | 5.0 ± 1.0 N.m (44 ± 9 in-lb) |
| Engine control system | |
| Accelerator pedal assembly nut | 13 ± 2 N.m (111 ± 22 in-lb) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.