Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Mitsubishi Outlander LS, FWDFACTORY OEM SERVICE PROCEDURE
Automatic Transaxle
- General Description
- Special Tools
- On-Vehicle Service
- A/T Control Component Layout
- Essential Service
- A/T Fluid Replacement
- Flushing Coolers And Tubes
- Oil Cooler Flow Check
- TP Sensor Adjustment
- Park/Neutral Position Switch Continuity Check
- Park/Neutral Position Switch And Control Cable Adjustment
- Automatic Transaxle Control Component Check
- A/T Fluid Temperature Sensor Continuity Check
- Park/Neutral Position Switch Check
- Stoplight Switch Check
- Select Switch Check
- Shift Switch (Up) Check
- Shift Switch (Down) Check
- A/T Control Relay Check
- Solenoid Valve Check
- Transfer Oil Level Check
- Transfer Oil Replacement
- Selector Lever Operation Check
- Key Interlock And Shift Lock Mechanism Check
- Transaxle Control
- A/T Key Interlock And Shift Lock Mechanisms
- Transaxle Assembly
- Transfer Assembly
- A/T Fluid Cooler
- Specifications
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
