Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Mitsubishi Lancer LSFACTORY OEM SERVICE PROCEDURE
Symptom Procedures - Except Evolution
- Symptom Procedures
- Notes
- INSPECTION PROCEDURE 1: Engine does not Crank
- INSPECTION PROCEDURE 2: Does not Move Forward
- INSPECTION PROCEDURE 3: Does not Move Backward
- INSPECTION PROCEDURE 4: Does not Move (Forward or Backward)
- INSPECTION PROCEDURE 5: Engine Stalls when Moving Selector Lever from "N" to "D" or "N" to "R"
- INSPECTION PROCEDURE 6: Shift Shock when Shifting from "N" to "D" and Long Delay
- INSPECTION PROCEDURE 7: Shift Shock when Shifting from "N" to "R" and Long Delay
- INSPECTION PROCEDURE 8: Shift Shock when Shifting from "N" to "D" "N" to "R" and Long Delay
- INSPECTION PROCEDURE 9: Shift Shock and Slipping
- INSPECTION PROCEDURE 10: Early or Late Shifting All Gears
- INSPECTION PROCEDURE 11: Early or Late Shifting Some Gears
- INSPECTION PROCEDURE 12: No Diagnostic Trouble Codes (Does not Shift)
- INSPECTION PROCEDURE 13: Poor Acceleration
- INSPECTION PROCEDURE 14: Vibration
- INSPECTION PROCEDURE 15: Vehicle Shifts Differently with A/C Engaged
- INSPECTION PROCEDURE 16: Transaxle won't Downshift under Load with Auto-cruise Engaged.
- INSPECTION PROCEDURE 17: Vehicle Speed Signal System
- Symptom Procedures
- Notes
- INSPECTION PROCEDURE 1: Selector Lever can be Moved from "P" to "R" Position without Depressing Brake Pedal when Ignition Key is at any Position Other then "LOCK" (OFF) Position.
- INSPECTION PROCEDURE 2: Selector Lever cannot be Moved from "P" to "R" Position with Brake Pedal Depressed when Ignition Key is at any Position Other than "LOCK" (OFF) Position.
- INSPECTION PROCEDURE 3: Selector Lever can be Moved from "P" to "R" Position with Brake Pedal Depressed when Ignition Key is at "LOCK" (OFF) Position.
- INSPECTION PROCEDURE 4: Selector Lever cannot be Moved from "P" to "R" Position Smoothly.
- INSPECTION PROCEDURE 5: Selector Lever cannot be Moved from "R" to "P" Position.
- INSPECTION PROCEDURE 6: Ignition Key cannot be Turned to the "LOCK" (OFF) Position when Selector Lever is at "P" Position.
- INSPECTION PROCEDURE 7: Ignition Key can be Turned to the "LOCK" (OFF) Position when Selector Lever is at any Position Other than "P" Position.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
