Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Mitsubishi Lancer EvolutionFACTORY OEM SERVICE PROCEDURE
Section 12 (On-Vehicle Service- Except Evolution): General Description
WARNING: This page is about a different variant/trim than selected.
The 4G94 (2.0L) engine is an in-line four-cylinder engine. The cylinder numbers are assigned as 1-2-3-4 from the front of the engine (timing belt side). This engine's firing order is 1, 3, 4, 2.
General Specifications -- Engine
| ITEMS | SPECIFICATIONS | ||
|---|---|---|---|
| Type | In-line SOHC | ||
| Number of cylinders | 4 | ||
| Bore mm (in) | 81.5 (3.21) | ||
| Stroke mm (in) | 95.8 (3.77) | ||
| Engine displacement cm3 (cu. in) | 1,999 (122.0) | ||
| Compression ratio | 9.5 | ||
| Firing order | 1-3-4-2 | ||
| Valve timing | Intake valve | Opens (BTDC) | 2Β° |
| Closes (ABDC) | 58Β° | ||
| Exhaust valve | Opens (BBDC) | 58Β° | |
| Closes (ATDC) | 10Β° | ||
| Lubrication | Pressure feed full-flow filtration | ||
| Oil pump type | Trochoid type | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
