2003 Mitsubishi Lancer EvolutionFACTORY OEM SERVICE PROCEDURE

Lancer, Lancer Evolution VIII & Outlander

Remove the rear seat assembly. Remove the protector. Disconnect the fuel pump module connector. See Fig 1-Fig 3. After starting the engine and letting it run until it stops naturally, turn the ignition off. Connect the fuel pump module connector. Install the protector and rear seat assembly.

Fig 1: Fuel Pump Module Connector (Lancer)
G00229857Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.