Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Mitsubishi Lancer EvolutionFACTORY OEM SERVICE PROCEDURE
Ignition Coil Check (Montero Sport)
- Measure primary coil resistance between each ignition coil terminal. See IGNITION COIL RESISTANCEΒ table.
- Measure secondary coil resistance between each ignition coil high-voltage terminal as follows:
- Cylinders No. 3 and 6 coil - A coil.
- Cylinders No. 1 and 4 coil - B coil.
- Cylinders No. 2 and 5 coil - C coil.
See IGNITION COIL RESISTANCEΒ table for standard resistance values.
IGNITION COIL RESISTANCE
| Application | Primary Coil (Ohms) | Secondary Coil (Ohms) | |
|---|---|---|---|
| Diamante | 0.5-0.7 | 9,000-13,000 | |
| Eclipse, Eclipse Spyder & Galant | |||
| 2.4L | ..... | 8,500-11,500 | |
| 3.0L | 0.56-0.68 | 9,400-12,800 | |
| Lancer, Lancer Evolution VIII & Montero | ..... | 8,500-11,500 | |
| Montero Sport | 0.74-0.90 | 20,100-27,300 | |
| Outlander | ..... | 8,500-11,500 | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
