Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Mitsubishi Lancer EvolutionFACTORY OEM SERVICE PROCEDURE
General Service Specifications: Specifications
COOLING SYSTEM SPECIFICATIONS
| Application | Specification | |||
|---|---|---|---|---|
| Coolant Replacement Interval | (1) | |||
| Coolant Capacity (Includes Heater & Reserve Tank) | 5.3 Qts. (5.0L) | |||
| Pressure Cap | 14-18 psi | |||
| Thermostat Opens | ||||
| Starts To Open | 177-183°F (80.5-83.5°C) | |||
| Fully Open | 203°F (95°C) | |||
|
||||
THERMOSTAT R & I
For Lancer, refer to THERMOSTAT . For Lancer Evolution, refer to THERMOSTAT .
WATER PUMP R & I
For Lancer, refer to WATER PUMP . For Lancer Evolution, refer to THERMOSTAT .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
