Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Mitsubishi Lancer LSFACTORY OEM SERVICE PROCEDURE
Automatic Transmission DTCS
AUTOMATIC TRANSMISSION DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | OBD-II DTC | Description |
|---|---|---|
| 15 | P0713 | Transmission Fluid Temperature Sensor Circuit - Open |
| 16 | P0712 | Transmission Fluid Temperature Sensor Circuit - Shorted |
| 22 | P0715 | Input Shaft Speed Sensor Circuit - Open/Shorted |
| 23 | P0720 | Output Shaft Speed Sensor Circuit - Open/Shorted |
| 27 | P0705 | Park/Neutral Position Switch - Open |
| 28 | P0705 | Park/Neutral Position Switch - Short Circuit |
| 31 | P0753 | Low-Reverse Solenoid Circuit - Open/Shorted |
| 32 | P0758 | Underdrive Solenoid Circuit - Open/Shorted |
| 33 | P0763 | Second Solenoid Valve Circuit - Open/Shorted |
| 34 | P0768 | Overdrive Solenoid Valve Circuit - Open/Shorted |
| 36 | P0743 | Torque Converter Clutch Circuit - Open/Shorted |
| 41 | P0731 | 1st Gear Ratio Incorrect |
| 42 | P0732 | 2nd Gear Ratio Incorrect |
| 43 | P0733 | 3rd Gear Ratio Incorrect |
| 44 | P0734 | 4th Gear Ratio Incorrect |
| 46 | P0736 | Reverse Gear Ratio Incorrect |
| 52 | P0741 | Torque Converter Clutch Solenoid - Defective |
| 53 | P0742 | Torque Converter Clutch Solenoid - Stuck On |
| 54 | P1751 | A/T Control Relay Circuit Open/Shorted To Ground |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
