2002 Mitsubishi Lancer LSFACTORY OEM SERVICE PROCEDURE

Service Intervals & Specifications

REPLACEMENT INTERVALS

Component Miles
Diamante
Air Filter 30,000
Automatic Transaxle Fluid (1)
Coolant (2) 30,000
Oil (3) 7500
Oil Filter (4) 15,000
Spark Plugs 60,000
Spark Plug Wires 60,000
Timing Belt (5) 60,000
Eclipse, Galant & Lancer
Air Filter 30,000
Automatic Transaxle Fluid (1)
Coolant (6)
Oil (3) 7500
Oil Filter (4) 15,000
Spark Plugs
Except Platinum 30,000
Platinum 60,000
Spark Plug Wires 60,000
Timing Belt (7) 60,000
Mirage
Air Filter 30,000
Automatic Transaxle Fluid (1)
Coolant (6)
Oil (3) 7500
Oil Filter (4) 15,000
Spark Plugs 30,000
Spark Plug Wires 60,000
Timing Belt (5) 60,000
Montero
Air Filter 30,000
Automatic Transmission Fluid (8)
Coolant (6)
Front & Rear Axle Fluid (9) 30,000
Oil (3) 7500
Oil Filter (4) 15,000
Spark Plugs (10) 60,000
Spark Plug Wires 60,000
Timing Belt (5) 60,000
Montero Sport
Air Filter 30,000
Automatic Transmission (1)
Axle Fluid (9) 30,000
Coolant (6)
Oil (3) 7500
Oil Filter (4) 15,000
Spark Plugs
Except Iridium 30,000
Iridium 60,000
Spark Plug Wires 60,000
Timing Belt (5) 60,000
(1) Change fluid every 30,000 miles under severe service conditions only.
(2) Replace coolant every 2 years if annual mileage is less than 15,000 miles.
(3) Replace oil every year if annual mileage is less than 7500 miles.
(4) Replace oil filter at oil change if annual mileage is less than 7500 miles.
(5) On California, Massachusetts & Connecticut vehicles, changing timing belt at 60,000 miles is recommended, but not required. Change timing belt at 100,000 miles, if not previously changed.
(6) Change coolant at first 4 years or 60,000 miles, then change after every 2 years or 30,000 miles.
(7) On California vehicles, changing timing belt at 60,000 miles is recommended, but not required. Change timing belt at 100,000 miles, if not previously changed.
(8) Inspect fluid every year or 15,000 miles. Under severe service conditions, change fluid every 30,000 miles.
(9) With limited-slip differential, change fluid every 30,000 miles. Without limited-slip differential, check fluid level every 30,000 miles.
(10) Use Platinum spark plugs only.
BELT ADJUSTMENT

Application (1) Deflection New Belt - In. (mm) (1) Deflection Used Belt - In. (mm)
Diamante
A/C & Generator .24-.28 (6.0-7.2) .32-.37 (8.2-9.3)
P/S .33-.37 (8.4-9.3) .46-.52 (11.7-13.4)
Eclipse & Galant
2.4L
A/C & P/S .34-.43 (8.8-11.0) .49-.56 (12.5-14.3)
Generator .20-.25 (5.0-6.4) .28-.33 (7.2-8.4)
3.0L
A/C & Generator .24-.30 (6.2-7.6) .35-.40 (9.0-10.0)
P/S .33-.37 (8.4-9.3) .46-.53 (11.7-13.3)
Lancer
A/C & P/S .27-.35 (7.0-9.0) .39-.43 (10.0-11.0)
Generator .26-.33 (6.7-8.5) .41-.47 (10.5-12.0)
Mirage
1.5L
A/C & P/S .28-.35 (7.2-9.0) .40-.46 (10.2-11.6)
A/C With No P/S .13-.17 (3.4-4.3) .20-.22 (5.0-5.7)
Generator .26-.33 (6.6-8.3) .36-.42 (9.2-10.6)
1.8L
A/C & P/S .28-.35 (7.0-9.0) .39-.43 (10.0-11.0)
Generator .28-.31 (7.0-8.0) .33-.39 (8.5-10.0)
Montero (2) (2)
Montero Sport
3.0L
A/C & Tensioner .16-.20 (4.3-5.1) .22-.25 (5.6-6.4)
Crankshaft Pulley & Water Pump .15-.19 (4.0-5.0) .21-.25 (5.5-6.5)
Generator & Water Pump .21-.29 (5.5-7.5) .31-.35 (8.0-9.0)
P/S & Water Pump .37-.45 (9.5-11.5) .45-.53 (11.5-13.5)
3.5L
A/C & Tensioner .42-.50 (10.7-13.7) .58-.66 (14.8-16.8)
Crankshaft Pulley & Water Pump .21-.29 (5.5-7.5) .31-.35 (8.0-9.0)
Generator & Water Pump .15-.19 (4.0-5.0) .21-.25 (5.5-6.5)
P/S & Water Pump .16-.20 (4.3-5.1) .22-.25 (5.6-6.4)
(1) With 22 lbs. (10 kg) pressure applied on longest belt run midway between pulleys.
(2) Uses serpentine belt with automatic belt tensioner.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.