Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Mitsubishi Lancer LSFACTORY OEM SERVICE PROCEDURE
Diagnostic Trouble Code Definitions
DIAGNOSTIC TROUBLE CODE DEFINITIONS
| DTC | (1) System Affected | ||||||
|---|---|---|---|---|---|---|---|
| 11 | Right Front Wheel Speed Sensor - Open Or Short Circuit | ||||||
| 12 | Left Front Wheel Speed Sensor - Open Or Short Circuit | ||||||
| 13 | Right Rear Wheel Speed Sensor - Open Or Short Circuit | ||||||
| 14 | Left Rear Wheel Speed Sensor - Open Or Short Circuit | ||||||
| 16 (2) | ABS Electronic Control Unit Power Supply | ||||||
| 21 | Right Front Wheel Speed Sensor - No Output Signal Or Implausible Signal | ||||||
| 22 | Left Front Wheel Speed Sensor - No Output Signal Or Implausible Signal | ||||||
| 23 | Right Rear Wheel Speed Sensor - No Output Signal Or Implausible Signal | ||||||
| 24 | Left Rear Wheel Speed Sensor - No Output Signal Or Implausible Signal | ||||||
| 33 | Stoplight Switch Circuit | ||||||
| 41 | Right Front Solenoid Valve Drive Circuit - Open Or Short | ||||||
| 42 | Left Front Solenoid Valve Drive Circuit - Open Or Short | ||||||
| 43 | Right Rear Solenoid Valve Drive Circuit - Open Or Short | ||||||
| 44 | Left Rear Solenoid Valve Drive Circuit - Open Or Short | ||||||
| 52 (3) | Valve Relay Problem - Stays Off | ||||||
| 53 | Motor Relay - Stays Off | ||||||
| 55 | Motor System - Seized Pump Motor | ||||||
| 63 (3) | Faulty ABS ECU/Hydraulic Unit | ||||||
|
|||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
