Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Mitsubishi MonteroFACTORY OEM SERVICE PROCEDURE
Scan Tool Will Not Communicate
NOTE:
For terminal identification, see
TERMINAL IDENTIFICATION in SELF-DIAGNOSTICS - INTRODUCTION article. For circuit and wire color identification, see appropriate wiring diagram
WIRING DIAGRAMS article.
- Check voltage between ground and OBD-II Data Link Connector (OBD-II DLC) terminal No. 16. If battery voltage exists, go to next step. If battery voltage does not exist, repair connectors and/or wiring between OBD-II DLC and power supply.
- Check resistance between ground and OBD-II DLC terminals No. 4 and 5. If resistance is not zero ohms, repair wiring between ground and OBD-II DLC. If resistance is zero ohms, try a different scan tool adapter cable. If scan tool does not communicate, try scan tool on known-good vehicle. If scan tool still does not communicate, repair or replace scan tool.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
