2000 Mitsubishi Eclipse GT, AutomaticFACTORY OEM SERVICE PROCEDURE

Abs Power Relay: AWD

  1. Remove ABS power relay. Disconnect relay connector. Using a DVOM, check for continuity between terminals No. 1 and 3. See Fig 1 . If continuity exists, replace relay.
  2. If no continuity exists, check for continuity between terminals No. 2 and 4. If continuity exists, go to next step. If no continuity exists, replace relay.
  3. Apply battery voltage to terminal No. 2, and ground terminal No. 4. Check for continuity between terminals No. 1 and 3. If continuity exists, relay is okay. If continuity does not exist, replace relay.
Fig 1: Testing ABS Relay (Eclipse 2.0L AWD)
G91G08042Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.