1999 Mitsubishi MonteroFACTORY OEM SERVICE PROCEDURE

EGR Monitor

This monitor applies to DTC P0400. Following conditions must be met during the test:

  • Engine coolant temperature must be 176°F (80°C) or more.
  • Atmospheric temperature is 41°F (5°C) or more.
  • If automatic transmission, selector lever is in "D" range.
  • If applicable, overdrive switch is in ON position.
  • If applicable, power/economy changeover switch is in POWER position.
  • A/C switch is in OFF position.

Monitor takes about 10 minutes to complete. To run monitor, use illustration. See Fig 1. Perform steps as follows:

  1. Start engine.
  2. Accelerate to 35-40 MPH.
  3. Keep speed constant for 20 seconds or more (M/T in 4th gear).
  4. Fully close throttle from engine speed of 2000-3000 RPM (keep clutch engaged if M/T) and decelerate to about 900 RPM without applying brakes. DO NOT turn steering wheel or operate light switch during this time.
  5. Accelerate to 35-40 MPH, then hold speed constant for 20 seconds or more (M/T: 4th gear). Repeat steps 4)  and 5)  seven more times.
  6. Return vehicle to shop and turn ignition off.
  7. Confirm DTC is not output. If DTC is output, go to appropriate DTC test in appropriate SELF-DIAGNOSTICS article.

Fig 1: Running EGR Monitor
G99J52604Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.