1999 Mitsubishi MonteroFACTORY OEM SERVICE PROCEDURE

Eclipse 2.0L Non-Turbo

Remove MFI (ASD) relay. Check resistance between relay terminals No. 4 and 6. Resistance should be 35-75 ohms. Connect jumper wire between battery positive terminal and relay terminal No. 6. Connect second jumper wire between battery negative terminal and MFI relay terminal No. 4. With relay energized, continuity should exist between terminals No. 2 and 8. With power source removed, continuity should not exist between terminals No. 2 and 8. If relay does not test as specified, replace MFI relay.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.