Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1999 Mitsubishi Eclipse GSX, AutomaticFACTORY OEM SERVICE PROCEDURE
Engine Controls - System & Component Testing
- Introduction
- Air Induction Systems
- Computerized Engine Controls
- Engine Sensors & Switches
- Notes
- Sensors
- Barometric Pressure Sensor
- Engine Coolant Temperature (ECT) Sensor
- Heated Oxygen Sensor (HO2S)
- Intake Air Temperature (IAT) Sensor
- Manifold Absolute Pressure (MAP) Sensor
- Manifold Differential Pressure (MDP) Sensor
- Throttle Position (TP) Sensor (Eclipse 2.0L Turbo & 2.4L, Galant 2.4L & Montero Sport 2.4L)
- Vehicle Speed Sensor (VSS)
- Volume Airflow Sensor
- Switches
- Motors, Relays & Solenoids
- Fuel System
- Idle Control System
- Ignition System
- Emission Systems & Sub-Systems
- Exhaust Gas RECIRCULATION (EGR)
- Notes
- EGR System Check (Eclipse 2.0L Non-Turbo)
- EGR System Check (Eclipse 2.0L Turbo & 2.4L)
- EGR System Check (Galant, Montero, Montero Sport & 3000GT)
- EGR Solenoid Valve Check (Eclipse 2.0L Turbo)
- EGR Solenoid Valve Check (Eclipse 2.4L)
- EGR Solenoid Valve Check (Galant & Montero Sport)
- EGR Valve Check (Eclipse 2.0L Non-Turbo)
- Electric EGR Transducer Solenoid (Eclipse 2.0L Non-Turbo)
- Fuel Evaporation
- EVAP Control System Check (Eclipse, Galant & Montero Sport)
- Purge Solenoid Valve (PSV) (Eclipse 2.0L Non-Turbo)
- Purge Solenoid Valve (PSV) (Eclipse 2.0L Turbo & 2.4L, Galant & Montero Sport)
- Vent Solenoid Valve (VSV) (Eclipse 2.0L Non-Turbo)
- Vent Solenoid Valve (VSV) (Eclipse 2.0L Turbo & 2.4L, Galant & Montero Sport)
- Positive Crankcase Ventilation (PCV)
- Exhaust Gas RECIRCULATION (EGR)
- Miscellaneous Controls
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
