1999 Mitsubishi Eclipse GSX, AutomaticFACTORY OEM SERVICE PROCEDURE

Verifying Repairs: Notes

If verifying repair on Eclipse 2.0L non-turbo, go to SYSTEM READINESS TEST PROCEDUREΒ . If verifying repair on all vehicles except Eclipse 2.0L non-turbo, go to the appropriate monitor referred to from self-diagnostics or find monitor related to the DTC that was repaired. Then carry out the drive cycle described under that monitor.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.