Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1999 Mitsubishi Eclipse GSX, AutomaticFACTORY OEM SERVICE PROCEDURE
Terminal Identification
NOTE:
The following terminal illustrations are shown as viewed from component side of connector. Vehicles are equipped with different combinations of components. Not all components are used on all models. To determine component usage, see appropriate wiring diagram in
WIRING DIAGRAMS article.
TERMINAL IDENTIFICATION DIRECTORY
| Connector | See |
|---|---|
| ASD/Fuel Pump/MFI Relay | Fig 1-Fig 3 |
| CKP/CMP Sensor | Fig 4-Fig 10 |
| DLC | Fig 11 |
| ECM | Fig 12-Fig 17 |
| ECT Sensor | Fig 18-Fig 19 |
| EVAP Purge Solenoid Valve | Fig 20-Fig 22 |
| EVAP Vent Solenoid Valve | Fig 23-Fig 24 |
| Fuel Injector | Fig 25-Fig 31 |
| Fuel Injector Resistor Block | Fig 32 |
| Fuel Pump | Fig 33-Fig 38 |
| Fuel Pump Relay Module | Fig 39 |
| FTDP Sensor | Fig 40 |
| Generator Field | Fig 41-Fig 42 |
| HO2S | Fig 43-Fig 44 |
| IAC Motor | Fig 45-Fig 46 |
| IAT Sensor | Fig 47-Fig 48 |
| Ignition Coil | Fig 49-Fig 56 |
| Ignition Failure Sensor | Fig 57 |
| KS | Fig 58-Fig 60 |
| Leak Detection Pump | Fig 61 |
| MAP Sensor | Fig 62-Fig 63 |
| MDP Sensor | Fig 64 |
| PCM | Fig 65-Fig 67 |
| PNP Switch | Fig 68-Fig 72 |
| Starter Relay | Fig 73-Fig 74 |
| TCM | Fig 75-Fig 78 |
| TP Sensor | Fig 79-Fig 80 |
| VAF Sensor | Fig 81-Fig 82 |
| VIC Valve Position Sensor | Fig 83 |
| VSS | Fig 84-Fig 85 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
