Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1998 Mitsubishi Eclipse GSX, StandardFACTORY OEM SERVICE PROCEDURE
3000GT (DOHC)
- Turn ignition off. Disconnect PCM connector. See POWERTRAIN CONTROL MODULE (PCM) LOCATIONΒ table under COMPUTERIZED ENGINE CONTROLS. Go to next step.
- Turn headlights on. Using DVOM, check voltage between PCM connector terminal No. 58 and chassis ground. If battery voltage is present, turn headlights off and go to next step. If battery voltage is not present, check and repair circuit between headlight relay connector and PCM connector.
- Turn defogger switch on. Using DVOM, check voltage between PCM connector terminal No. 58 and chassis ground. If battery voltage is present, turn defogger switch off and go to next step. If battery voltage is not present, check and repair circuit between defogger relay connector and PCM connector.
- Turn blower switch on. Using DVOM, check voltage between PCM connector terminal No. 58 and chassis ground. If battery voltage is present, turn blower switch off and go to next step. If battery voltage is not present, check and repair circuit between blower switch connector and PCM connector.
- If battery voltage is present and preceding tests do not show any system or component malfunction and PCM is suspected, substitute PCM with known-good unit and retest system.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
