1996 Mitsubishi Eclipse Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Power Window Switch

Remove control switch from trim panel. Using ohmmeter, check continuity of switch. See appropriate WINDOW SWITCH CONTINUITY TABLE. See Fig 1 or Fig 2 . Replace appropriate switch as necessary if switch continuity is not as specified.

MAIN WINDOW SWITCH CONTINUITY

Switch Position (1) Check Continuity Between Pins No.
Normal Position
Left Front OFF 2, 6 & 9
Left Front UP 2 & 6; Pins 8 & 9
Left Front DOWN 2 & 9; Pins 6 & 8
Right Front OFF 3 & 7
Right Front UP 3 & 8
Right DOWN 7 & 8
Window Lock Position
Normal 2 & 3; 2 & 7
Lock No Continuity
(1) Left side of vehicle refers to driver's side.
Fig 1: Main Switch Connector Terminals
G96E06928Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
PASSENGER SIDE (SUB) WINDOW SWITCH CONTINUITY

Switch Position Check Continuity Between Pins No.
OFF 1 & 4; Pins 2 & 3
UP 1 & 4; 3 & 6
DOWN 1 & 6; 2 & 3
Fig 2: Sub Switch Connector Terminals
G96I06930Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.