1994 Mitsubishi Eclipse Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Power Window Switch

Remove control switch from trim panel. Using ohmmeter, check continuity of switch. See the MASTER WINDOW SWITCH CONTINUITY CHARTΒ  or the PASSENGER SIDE WINDOW SWITCH CONTINUITY CHARTΒ  . Also, seeFigure . Replace appropriate switch as necessary if switch continuity is not as specified.

MASTER WINDOW SWITCH CONTINUITY CHART

Switch Position (1) Check Continuity Between
Normal Position
Left Front OFF Pins 2, 3 & 6
Left Front UP Pins 2 & 3; Pins 5 & 6
Left Front DOWN Pins 2 & 5; Pins 3 & 6
Right Front OFF Pins 1, 3 & 4
Right Front UP Pins 1 & 3; Pins 4 & 5
Right DOWN Pins 1 & 5; Pins 3 & 4
Lock Position
Left OFF Pins 2, 3 & 6
Left UP Pins 2 & 3; Pins 5 & 6
Left DOWN Pins 2 & 5; Pins 3 & 6
Right OFF Pins 1 & 4
Right UP Pins 4 & 5
Right DOWN Pins 1 & 5
(1) Left side of vehicle refers to driver's side.
PASSENGER SIDE WINDOW SWITCH CONTINUITY CHART

Switch Position Check Continuity Between
OFF Pins 2 & 4; Pins 3 & 5
UP Pins 2 & 4; Pins 5 & 6
DOWN Pins 3 & 5; Pins 4 & 6
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.