Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

1993 Mitsubishi Precis AutomaticFACTORY OEM SERVICE PROCEDURE

Wheel Alignment Specifications

WHEEL ALIGNMENT SPECIFICATIONS

Application

Preferred

Range

Camber ⁽¹⁾

Front

-0.5 To 0.5

Rear

-0.67

N/A

Caster ⁽¹⁾

With P/S

1.67

1.17 To 2.17

Without P/S

1.03

0.53 To 1.53

Toe-In ⁽¹⁾

Front

0.08

-0.16 To 0.32

Rear

0.12

-0.24 To 0.46

Toe-In ⁽²⁾

Front

0.04 (1)

-0.08 To 0.16 (-2 To 4)

Rear

0.06 (1.5)

-012 To 0.23 (3 To 6)

Toe-Out On Turns ⁽¹⁾

Inner

37.4

N/A

Outer

31.52

N/A

⁽¹⁾	Measurement in degrees.

⁽²⁾	Measurement in inches (mm).

Chapter Navigation

Return to Chapter: Wheel Alignment Specifications & Procedures

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.