1993 Mitsubishi Precis AutomaticFACTORY OEM SERVICE PROCEDURE

Scan Tester Procedure

Connect tachometer and scan tester to vehicle. Access EGR temperature sensor service data item No. 43. Tester should display sensor temperature. With engine at normal operating temperature and idling at 750 RPM for at least 2 minutes, check sensor temperature. Scan tester should display 158°F (70°C) or less. Accelerate engine to 3500 RPM. Scan tester should display 158°F (70°C) or more.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.