1993 Mitsubishi Precis AutomaticFACTORY OEM SERVICE PROCEDURE

Scan Tester Procedure

  1. Access fuel injector service data item No. 41. Scan tester should display injector drive time. Ensure engine is at normal operating temperature. Turn all accessories off. Ensure shift selector is in Park or Neutral.
  2. Inspect fuel injector drive times with engine cranking and running. See FUEL INJECTOR DRIVE TIME  table.
    FUEL INJECTOR DRIVE TIME

    Coolant Temp. °F (°C) Engine RPM Drive Time (ms)
    Engine Cranking
    32 (0) Less than 250 18
    68 (20) Less than 250 34
    176 (80) Less than 250 6.1
    Engine Running
    176 (80) 750 2.5-3.1
    176 (80) 2000 2.2-2.8
  3. Access injector actuator test. Select items 01 through 04 for injectors No. 1 through No. 4. Check decrease in engine idle speed when each injector is disabled to confirm injector operation.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.