Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Mitsubishi Eclipse Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Wheel Alignment Specifications
WHEEL ALIGNMENT SPECIFICATIONS
| Application | Preferred | Range | |||||||
|---|---|---|---|---|---|---|---|---|---|
| 1.8L | |||||||||
| Camber (1) | |||||||||
| Front | 0.23 | -0.27 To 0.73 | |||||||
| Rear | -0.75 | -1.25 To -0.25 | |||||||
| Caster (1) | 2.33 | 1.83 To 2.83 | |||||||
| Toe-In (1) | |||||||||
| Front & Rear | 0 | -0.24 To 0.24 | |||||||
| Toe-In (2) | |||||||||
| Front & Rear | 0 (0) | -0.12 To 0.12 (-3 To 3) | |||||||
| 2.0L | |||||||||
| 2WD | |||||||||
| Camber (1) | |||||||||
| Front | 0.08 | -0.03 To 0.11 | |||||||
| Rear | -0.75 | -1.25 To -0.25 | |||||||
| Caster (1) | 2.4 | 1.9 To 2.9 | |||||||
| Toe-In (1) | 0 | -0.24 To 0.24 | |||||||
| Toe-In (2) | 0 (0) | -0.12 To 0.12 (-3 To 3) | |||||||
| 4WD | |||||||||
| Camber (1) | |||||||||
| Front | 0.17 | -0.33 To 0.67 | |||||||
| Rear | -1.55 | -2.05 To -1.05 | |||||||
| Caster (1) | 2.3 | 1.8 To 2.8 | |||||||
| Toe-In (1) | |||||||||
| Front | 0 | -0.24 To 0.24 | |||||||
| Rear | 0.28 | 0.04 To 0.52 | |||||||
| Toe-In (2) | |||||||||
| Front | 0 (0) | -0.12 To 0.12 (-3 To 3) | |||||||
| Rear | 0.14 (3) | -0.02 To 0.26 (0.5 To 6.5) | |||||||
|
|||||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
