Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Mitsubishi Eclipse Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Terminal Identification
NOTE:
The following terminals are shown as viewed from component side.
TERMINAL ID DIRECTORY
| Connector | Illustration |
|---|---|
| Airflow Sensor | Fig 1 , Fig 2 , Fig 3 |
| CKP/CMP Sensor | Fig 4 , Fig 5 |
| Coolant Temperature Sensor | Fig 6 |
| ECM | Fig 7 , Fig 8 |
| EGR Temperature Sensor | Fig 9 |
| Fuel Injector | Fig 10 |
| Fuel Pump | Fig 11 |
| Idle Air Control Valve Position Sensor | Fig 12 |
| Idle Speed Control Motor & Position Sensor | Fig 13 |
| Ignition Coil | Fig 14 , Fig 15 |
| Induction Control Valve Position Sensor | Fig 16 |
| Knock Sensor | Fig 17 |
| MAP Sensor | Fig 18 |
| MPI Relay | Fig 19 |
| Oxygen (O2) Sensor | Fig 20 , Fig 21 , Fig 22 , Fig 23 |
| Throttle Position Sensor | Fig 24 |
| Traction Control Vacuum Solenoid | Fig 25 |
| Traction Control Vent Solenoid | Fig 26 |
| Transaxle Control Module | Fig 27 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.