1992 Mitsubishi Expo Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Verification Test VER-1

  1. Reconnect and reassemble all components. Ensure all intake hoses are in good condition and are installed properly. Start engine. Allow engine to idle for about one minute. Raise engine speed to 3000 RPM then return engine speed to idle.
  2. To reset Codes 11 (oxygen sensor), 24 (vehicle speed sensor) or 43 (EGR temperature sensor), vehicle must be test driven. Test drive vehicle if any of these codes were previously stored.
  3. Check for fault codes. If any codes are present, return to TEST DR-1A - CHECKING FAULT CODESΒ  .
  4. If no fault codes are present, but vehicle driveability is poor, perform TEST DR-14A - NO FAULT CODE SWITCH TESTSΒ  .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.