1991 Mitsubishi Precis Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Alignment Specifications: Precis

WHEEL ALIGNMENT SPECIFICATIONS (PRECIS)

Application Preferred Range
Camber (Degrees)
Front 0 -1/2 to 1/2
Rear -11/16 -1 to -3/16
Caster (Degrees)
With P/S 1 11/16 1 3/16 to 2 3/16
Without P/S 1 1/2 to 1 1/2
Toe-In (In. (mm))
Front 1/32 (1) -1/16 to 5/32 (-2 to 4)
Rear 0 (0) N/A
Toe-In (Degrees)
Front 1/16 -1/8 to 5/16
Rear 0 N/A
Toe-Out on Turns (Degrees)
Inner 37 3/8 N/A
Outer 31 1/2 N/A
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.