Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1991 Mitsubishi Precis Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Alignment Specifications: GALANT
WHEEL ALIGNMENT SPECIFICATIONS (GALANT)
| Application | Preferred | Range | ||
|---|---|---|---|---|
| Two Wheel Drive | ||||
| Camber (Degrees) | ||||
| Front | 3/8 | -1/8 to 7/8 | ||
| Rear | -3/4 | -1 1/4 to -1/4 | ||
| Caster (Degrees) | 2 | 1 1/2 to 2 1/2 | ||
| Toe-In (In. (mm)) | ||||
| Front & Rear | 0 (0) | -1/8 to 1/8 (-3 to 3) | ||
| Toe-In (Degrees) | ||||
| Front & Rear | 0 | -1/4 to 1/4 | ||
| Four Wheel Drive | ||||
| Camber (Degrees) | ||||
| Front | 1/2 | 0 to 1 | ||
| Rear | -1 | -1 1/2 to -1/2 | ||
| Caster (Degrees) | 1 15/16 | 1 7/16 to 2 7/16 | ||
| Toe-In (In. (mm)) | ||||
| Front | 0 (0) | -1/8 to 1/8 (-3 to 3) | ||
| Rear | 1/8 (3) | 0 to 1/4 (0 to 6.4) | ||
| Toe-In (Degrees) | ||||
| Front | 0 | -1/4 to 1/4 | ||
| Rear | 1/4 | 0 to 1/2 | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
