1991 Mitsubishi Precis Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Alignment Specifications: Eclipse

WHEEL ALIGNMENT SPECIFICATIONS (ECLIPSE)

Application Preferred Range
1.8L Engine
Camber (Degrees)
Front 1/4 -1/4 to 3/4
Rear -3/4 -1 1/4 to -1/4
Caster (Degrees) 2 5/16 1 13/16 to 2 13/16
Toe-In (In. (mm))
Front & Rear 0 (0) -1/8 to 1/8 (-3 to 3)
Toe-In (Degrees)
Front & Rear 0 -1/4 to 1/4
2.0L Engine (2WD)
Camber (Degrees)
Front 1/16 -7/16 to 9/16
Rear -3/4 -1 1/4 to -1/4
Caster (Degrees) 2 3/8 1 7/8 to 2 7/8
Toe-In (In. (mm))
Front & Rear 0 (0) -1/8 to 1/8 (-3 to 3)
Toe-In (Degrees)
Front & Rear 0 -1/4 to 1/4
2.0L Engine (4WD)
Camber (Degrees)
Front 3/16 -5/16 to 11/16
Rear -1 9/16 -2 1/16 to -1 1/16
Caster (Degrees) 2 5/16 1 13/16 to 2 13/16
Toe-In (In. (mm))
Front 0 (0) -1/8 to 1/8 (-3 to 3)
Rear 9/64 (3.6) -1/32 to 1/4 (-.6 to 6.6)
Toe-In (Degrees)
Front 0 -1/4 to 1/4
Rear 9/32 1/16 to 1/2
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.