Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1991 Mitsubishi Eclipse Base, StandardFACTORY OEM SERVICE PROCEDURE
Ignition Coil Resistance (Eclipse 2.0L)
- Using a DVOM, measure primary coil resistance between ignition coil connector terminals No. 2 and No. 4 (coils for cylinders No. 1 and No. 4) and between terminals No. 4 and No. 1 (coils for cylinders No. 2 and No. 3). See Figure .
- Measure secondary coil resistance between coil towers for cylinders No. 1 and No. 4 and between coil towers for cylinders No. 2 and No. 3. See Figure
. Primary and secondary coil resistance should be within specification. See DIS IGNITION COIL RESISTANCE
table.DIS IGNITION COIL RESISTANCE Ohms @ 68°F (20°C)
Application Primary Secondary All Models .77-.95 10.3-13.9
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.