Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Mitsubishi SigmaFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS LOCATION
| Component | Location |
|---|---|
| Automatic A/C Control Unit | Under center of dash. See Figure . |
| Auto-Cruise Control Unit | Under left side of dash. See Figure . |
| Anti-Lock Brake Control Unit | Behind left side of luggage compartment. |
| Electronic Suspension Control Unit | Behind right side of luggage compartment. See Figure . |
| Multi Point Injection (MPI) Control Unit | Under right side of dash. See Figure . |
| Power Steering Control Unit | Behind center console. |
| Theft & Alarm Control Unit (ETACS) | Under left side of dash, behind auto-cruise control unit. See Figure . |
| Transaxle Control Unit | In center of dash, under heater unit. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
