Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI1990PRECIS BASE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALSTARTERBENCH TESTINGRETURN TEST
1990 Mitsubishi Precis Base, Standard
Return Test
1990 Mitsubishi Precis Base, StandardSECTION Return Test
- Disconnect field coil wire from terminal "M" at starter solenoid. See Figure. Connect jumper wire between positive battery terminal of 12-volt battery and terminal "M" of starter solenoid.
- Connect a second jumper wire from negative battery terminal and touch starter case. Pull pinion outward and release it. Replace solenoid if pinion remains outward.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.