1990 Mitsubishi Precis Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Wheel Alignment Specifications

WHEEL ALIGNMENT SPECIFICATIONS (MIRAGE)

Application Specification: Fraction (Decimal)
Camber (Degrees) 0 +/- 1/2 (0 +/- .50)
Caster (Degrees) 2 5/16 +/- 1/2 (2.3 +/- .50)
Toe-In (Degrees) 0 +/- 1/4 (0 +/- .25)
Toe-In (Inches) 0 +/- 1/8 (0 +/- .12)
Degrees 
Steering Angle (Inner Wheel)
Mirage LS w/ Power Steering & P175/70 R13 Tires 37°
All Other Mirage Models 41°
WHEEL ALIGNMENT SPECIFICATIONS (PRECIS)

Application Fraction Decimal
Camber (Degrees) 0 +/- 1/2 0 +/- .50
Caster (Degrees)
With Power Steering 1 11/16 +/- 1/2 1.67 +/- .50
Without Power Steering 1 1/32 +/- 1/2 1.03 +/- .50
Toe-In (Degrees) 1/16 +/- 1/4 .08 +/- .25
Toe-In (Inches) 1/32 +/- 1/8 .04 +/- .12
WHEEL ALIGNMENT SPECIFICATIONS (SIGMA)

Application Fraction Decimal
Camber (Degrees) (1)(2) 1/2 +/- 1/2 .50 +/- .50
Caster (Degrees) (1)(2) 21/32 +/- 1/2 .67 +/- .50
Toe-In (Degrees) 0 +/- 1/4 0 +/- .25
Toe-In (Inches) 0 +/- 1/8 0 +/- .12
(1) Use King Pin Gauge (MB991004-01).
(2) Maximum difference between right and left wheels is .5 degree.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.