Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1989 Mitsubishi Sigma StandardFACTORY OEM SERVICE PROCEDURE
System/Component Tests - EFI
- Introduction
- Air Induction Systems
- Engine Sensors & Switches
- System/Component Tests - EFI
- Barometeric Pressure Sensor
- Coolant Temperature Sensor
- Crank Angle Sensor (Van/Wagon)
- Crank Angle Sensor (Montero)
- Crank Angle Sensor (All Others)
- Detonation Sensor
- Idle Switch (Galant 2.0L DOHC, Mirage 1.6L & Sigma)
- Idle Switch (Galant 2.0L SOHC, Mirage 1.5L & Van/Wagon)
- Idle Switch (Montero)
- Intake Air Temperature Sensor
- Motor Position Sensor (Galant 2.0L SOHC, Mirage 1.5L & Van/Wagon)
- Oxygen Sensor
- Power Steering Oil Pressure Switch (Mirage)
- Throttle Position Sensor (Montero)
- Throttle Position Sensor (Van/Wagon)
- Throttle Position Sensor (Galant 2.0L DOHC, Mirage 1.6L & Sigma)
- Throttle Position Sensor (Galant 2.0L SOHC & Mirage 1.5L)
- Transmission Inhibitor Switch (Galant A/T & Sigma A/T)
- Transmission Inhibitor Switch (Van/Wagon A/T)
- Vehicle Speed Sensor Input Circuit (Sigma)
- Vehicle Speed Sensor Reed Switch (Sigma)
- Vehicle Speed Sensor Reed Switch (All Others)
- System/Component Tests - EFI
- Relays, Solenoids, Motors & Modules
- System/Component Tests - EFI
- Control Relay (Galant 2.0L DOHC, Mirage 1.6L, Montero & Sigma)
- Control Relay (Mirage 1.5L, Galant 2.0L SOHC & Van/Wagon)
- ISC Motor Resistance Test (Galant 2.0L SOHC & Mirage 1.5L)
- ISC Motor Resistance Test (Sigma)
- ISC Motor Resistance Test (Galant 2.0L DOHC & Montero)
- ISC Motor Operation Test (Galant 2.0L SOHC & Mirage 1.5L)
- ISC Motor Operation Test (Sigma)
- ISC Motor Operation Test (Galant 2.0L DOHC, Mirage 1.6L & Montero)
- System/Component Tests - EFI
- Fuel System
- Ignition System
- Emission Systems & Sub-Systems
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
