Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1989 Mitsubishi Precis BaseFACTORY OEM SERVICE PROCEDURE
High Altitude Control (HAC) Valve (Precis)
- Remove HAC valve (located at rear of engine) and inspect for cracks and other damage. Clean HAC valve air filter.
- At altitude below 3900 feet. Disconnect vacuum hose from the valve and connect a vacuum pump to the valve lower nipple. Apply vacuum and ensure it bleeds off. Disconnnect vacuum hose from the valve lower nipple and connect vacuum pump to upper nipple. Ensure vacuum holds when applied.
- At altitude above 3900 feet, disconnect vacuum hose from HAC valve and connect a hand vacuum pump to the valve lower or upper nipple, ensure vacuum holds when applied. Replace valve if necessary.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
