1988 Mitsubishi Starion ESI-R, StandardFACTORY OEM SERVICE PROCEDURE

HAC System: Federal

  1. Ensure engine coolant temperature is 185-205°F (85-95°C). Remove air filter. Disconnect both Black vacuum hoses and Red-striped vacuum hose from carburetor primary and secondary main well bleed and jet air nipples. Plug nipples at carburetor. Connect a vacuum pump to vacuum hoses one at a time, and check while running engine at idle. On low altitude vehicles, 3900 ft. (1200 m) or less, system is okay if vacuum holds. On high altitude vehicles, system is okay if vacuum leaks.
  2. Reconnect hoses to carburetor. Run engine at idle and check ignition timing. See IGNITION TIMING SPECIFICATIONS  table. On low altitude vehicles, with engine at idle, disconnect Yellow-striped vacuum hose from HAC. No vacuum should be present.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.