Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1988 Mitsubishi Starion ESI-R, AutomaticFACTORY OEM SERVICE PROCEDURE
HAC System: California
- Ensure engine coolant temperature is 185-205°F (85-95°C). Remove air filter. Disconnect Black vacuum hose from carburetor primary main well bleed nipple and plug nipple at carburetor. Connect vacuum pump to vacuum hose and apply vacuum. On low altitude vehicles, 3900 ft. (1200 m) or less, vacuum should hold while running engine at idle. On high altitude vehicles, vacuum should leak.
- Reconnect hose to carburetor. Run engine at idle and check ignition timing. See IGNITION TIMING SPECIFICATIONS table. On low altitude vehicles, with engine at idle, disconnect White-striped vacuum hose from HAC. Vacuum should be present.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.