Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1988 Mitsubishi Precis BaseFACTORY OEM SERVICE PROCEDURE
Alignment Specifications
WHEEL ALIGNMENT SPECIFICATIONS
| Application | Specification | ||
|---|---|---|---|
| Front | |||
| Camber in Degrees | |||
| Fraction | 1/2 +/- 1/2 | ||
| Decimal | .50 +/- .50 | ||
| Caster in Degrees | |||
| Fraction | 1 +/- 1/4 | ||
| Decimal | 1.00 +/- .25 | ||
| Toe-In in Inches | |||
| Fraction | 3/64 +/- 1/8 | ||
| Decimal | .05 .13 | ||
| Toe-In in Degrees | |||
| Fraction | 5/64 +/- 1/4 | ||
| Decimal | .08 +/- .25 | ||
| Toe-Out on Turns | |||
| Inner | 35.6° | ||
| Outer | 29.3° | ||
| Steering Axis Inclination (SAI) | 12 3/4° | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.