Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Mitsubishi Starion ESI-RFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TIGHTENING SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Clutch Cover Bolt | 1-16 (15-22) | |
| Crossmember Bolt | ||
| Starion | 7 (10) | |
| All Others | 41-54 (55-75) | |
| Drain Plug | ||
| Transmission | 43 (60) | |
| Transfer Case | 22-25 (30-35) | |
| Flywheel-to-Crankshaft Bolts | 94-101 (130-140) | |
| Drive Shaft Bolt | 36-43 (50-60) | |
| Rear Engine Mount Bolt | ||
| Starion | 14-17 (20-24) | |
| All Others | 13-18 (18-25) | |
| Release Cylinder Bolt | 19-21 (26-29) | |
| Starter Mount Bolt | 16-23 (22-31) | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.