Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Mitsubishi Starion ESI-RFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Switches
SWITCHES LOCATION
| Component | Location |
|---|---|
| A/C Pressure Switch (W/Intercooler) | In A/C line, next to receiver-drier. |
| A/C Dual Pressure Switch | In A/C line, next to receiver-drier. |
| A/C Thermoswitch | On A/C evaporator housing. |
| Back-Up Light Switch | On right side of transmission. |
| Brake/Stoplight Switch | Above brake pedal. |
| Inhibitor Switch | On side of transmission. |
| Oil Pressure Switch | On front of engine block. |
| Parking Brake Switch | At base of parking brake lever. |
| Speed Control Vacuum Switch | In right rear corner of engine bay. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.